Dcos Monitoring DocumentationThis page describes how to download and install the DC/OS Monitoring service. By default, Prometheus and Grafana are run with the default configuration options. Alertmanager is off by default and must be configured to be turned on.
Prerequisites
- DC/OS 1.12 or later.
- DC/OS CLI is installed.
- You are logged in as a superuser.
Install DC/OS Monitoring service
Download the package
The DC/OS Monitoring package is installable via the catalog.
Install the service
Use the following command to install the service.
dcos package install dcos-monitoring --package-version=<VERSION>
NOTE: The command `dcos package install` will install the DC/OS Monitoring service and the package CLI.
DC/OS Monitoring CLI
You can install the DC/OS Monitoring CLI with the following command.
IMPORTANT: If you install DC/OS Monitoring via the DC/OS GUI, you must install the DC/OS Monitoring CLI as a separate step from the DC/OS CLI.
dcos package install dcos-monitoring --cli
Configure the DC/OS Monitoring CLI with the package name.
dcos config set monitoring.service_name dcos-monitoring
Verify service deployment
After installing the package CLI, you can monitor the deployment of your service by executing the following command:
dcos monitoring plan show deploy
You can also go to the Services > Deployments tab of the DC/OS GUI to monitor the deployment.
Access Grafana dashboards
WARNING: It is recommended to access Grafana via Edge-LB. If you access Grafana via AdminRouter then it can limit the capabilities of Grafana. For example, some graphs will not work under load.
Assuming the service name is dcos-monitoring (default), you should be able to access the Grafana dashboards using the following address:
https://<CLUSTER_URL>/service/dcos-monitoring/grafana/
Read more information about accessing the Grafana UI.